Original Research Open Access Logo

Investigating the existence of oxygen interstitial in CuCr1?xMgxO2 [0.00 X 0.30] thermoelectric materials by X-Ray photoelectron spectroscopy [XPS]

Dũng Hoàng Văn 1, *
Anh Tuấn Thanh Phạm 1
Thư Nguyễn Bảo Lê 1
Trương Hữu Nguyễn 1
Thắng Bách Phan 1
Vinh Cao Trần 1
  1. Laboratory of Advanced Materials, University of Science, HoChiMinh City, Vietnam
Correspondence to: Dũng Hoàng Văn, Laboratory of Advanced Materials, University of Science, HoChiMinh City, Vietnam. Email: hvdung@hcmus.edu.vn.
Volume & Issue: Vol. 5 No. 2 (2021) | Page No.: 1125-1134 | DOI: 10.32508/stdjns.v5i2.973
Published: 2021-04-30

Online metrics


Statistics from the website

  • Abstract Views: 562
  • Galley Views: 468

Statistics from Dimensions

This article is published with open access by Viet Nam National University Ho Chi Minh City, Viet Nam. This article is distributed under the terms of the Creative Commons Attribution License (CC-BY 4.0) which permits any use, distribution, and reproduction in any medium, provided the original author(s) and the source are credited.

Abstract

Climate change is promoting researches on materials which is capable of converting environmentally friendly energy, in which materials that convert heat into electricity are receiving significant attention, because their ability of converting heat to electricity not only generates the electricity but also contributes to slow down the consumption of fossil fuel. The existence of point defects in the semiconductors greatly effected properties of materials, especially thermoelectric properties. Therefore, the study of defects in materials is a popular research trend today. In this study, we focus on evaluating the existence of oxygen interstitial in CuCr1?xMgxO2 [0.00 x 0.30] compounds, because oxygen interstitial greatly affected the thermoelectric properties of this material. Based on X-ray photoelectron spectroscopy (XPS) analysis, at the large ratio of Mg impurity x = 0.15, the compound had the highest percentage of oxygen interstitial and was also a good thermoelectric material. In addition, it could be also seen that CuCrO2 material being doped a large Mg doping ratio (x = 0.15) was suitable for thermal-to-electrical applications rather than the ones with a small ratio (x 0.05).

Comments